Best Divers Bellatrix Pulsar Switch Assemble Replacement Part For Strobo and Lights

BELLATRIX PULSAR SWITCH ASSEMBLE REPLACEMENT PART FOR BESTDIVERS STROBO AND LIGHTS

Incorrect maintenance of our lamps can cause corrosion of the magnet located inside the ignition switch.
The small yet powerful magnet enables the illuminator to be switched on and off and should always be kept clean.
Always rinse your lamp thoroughly under a stream of fresh water, paying particular attention to the switch.
If your switch is oxidized it will need to be replaced.

Replacement switch assembly for Bestdivers light compatible with following models:

BELLATRIX
SUPER BELLATRIX
PULSAR
ALTAIR
ALDEBARAN
X-HUNT

Follow the pictures to clean/replace your switch and following insturctions:

1- Use a small screwdriver to remove the switch and a brush to clean the housing.
2- Insert the tip of the screwdriver under the sliding part and lift gently.
3- Remove the switch (note the presence of oxide).
4- Thoroughly clean the oxide residue with the brush and a cloth: if possible, lubricate with silicone grease.
5- Position the new switch, using the screwdriver to press down the sealing tabs.

Discover our range of dive lights, lighting accessories and battery packs and chargers.