Deox Sub Multigas Analyzer Oxygen, Helium, Carbon Monoxide Oled Display

DEOX SUB MULTIGAS ANALYZER OXYGEN, HELIUM, CARBON MONOXIDE OLED DISPLAY

DE-OX® SUB is a general purpose measurement instrument able to be connected to a large number of sensors in any combination of them. Its application includes continuous ambient gas monitoring, hyperbaric chambers, safety, medical, air quality etc.

Standard available configurations include:

• Oxygen
• Helium
• Carbon Dioxide
• Carbon Monoxide
• Humidity
• Gas temperature
• Pressure

It is possible to connect the instrument to many other sensors and to change the sensors and instrument configuration.

The instrument is installed into an extra heavy duty water proof Explorer case on an aluminum oven painted panel. It is easily possible to install the main instrument and the sensors in external panel.

Main Feature

• Fully digital analyzer with color display.
• Oxygen percentage indication in the mix within 0,0 to 100%. Resolution 0,1%. Long life electrochemical sensor.
• Helium indication in any Oxygen-Nitrogen mix in the range 0.0 – 100.0% of volume with 0,1 % resolution. Thermal conductivity stainless steel helium sensor developed for marine sport ambient.
• Large range of Carbon dioxide gas concentration (from 0-500ppm 0-0.05% to 0-100%). Resolution 20 ppm
• Carbon Dioxide NDIR (Non Dispersive Infra Red) sensor
• Carbon monoxide concentration 0-50 ppm or 0-300 ppm; resolution 1 ppm. Long life electrochemical sensor.
• Moisture reading of RH from 0,0 to 99,9% and absolute humidity in mg/m3 or PPMv. New capacitive technology sensor. Available dew point sensor up to -110°C
• Gas flow temperature within –20 to +80°C.
• Sensors status indication.
• Heavy duty waterproof Explorer case and internal aluminum panel.
• Independent audible and visible alarms for any sensor.
• Standard case Dimensions: 305x270x144 cm Weight 2 Kg ca
• Input voltage requirement:    10-35 Vdc
• Internal battery    Lithium ions rechargeable battery. One cell 1400 mAh Li ion 3.7 V
• Input:    Up to 6 sensor input
• Output:    On board acoustic buzzer alarm 2 electrical supply for external
• sensors or transducers
• Serial connection:    1 RS232 interface. Baud rate up to 115000 baud, on request RS485 interface
• Measure resolution:    24 bit bipolar A/D converter Drift in temperature automatic compensation
• Conversion rate:    10 ms
• Sampling time:    100 ms (min) for each channel
• Signal measurement accuracy:    0.1% Full Scale +/- ½ LSB
• Input device:    Rotary knob withy central push
• Colour display    TFT 320 x 240 dots resolution, backlight led.
• Display light intensity    600 nits (cd/m2)
• Memory    micro SD card writer/reader
• Microprocessor     Cortex M4

SOFTWARE Description

It is possible to set:

• Start Log
• Settings
• Brightness
• References
• Languages
• Units
• Alarm Configuraion
• Date and time
• Select skin
• Factory reset
• Calibration
• Alarm
• Export Data

Optional external Dew Point sensor. If an extra accuracy is required, it is possible to connect an external thin-film aluminum oxide moisture sensor for detection of humidity up to -110°C dew point (0.001 mg/m3 or 0.001 ppmV). In this configuration the instrument gives also absolute humidity and PPMV at 21.1°C (70°F) and 1 atm.